Q Acoustics 2000i Serie Manual De Usuario página 15

Connecting the 2070Si
Multi-Channel AV System
Setting Up
Do not adjust to more than +/-0.5m from the original measure distance
(for this example it would be from 3.5m to 4.5m). If it has not been
possible to discern any improvement in the tone, try swapping the phase
invert switch position on the 2070Si Subwoofer and repeat the exercise.
Then re-check the sound with some stereo music again to make sure an
improvement has been noticed.
If the 2070Si Subwoofer is subsequently moved relative to the other
speakers reset the amplifier subwoofer distance setting to the new value
and repeat the exercise. Once you are happy the optimum setting has
been achieved play track six to check the overall result. The sound
should be full and warm and integrated with no individual speaker been
dominant.
Stereo System
Connections
There are two connection options for stereo system operation. The
preferred option is to use a stereo RCA phono cable from your amplifiers
PRE-OUT sockets but if your amplifier does not have then you can use
the HIGH LEVEL inputs of your 2070Si.
AV AMPLIFIER
RIGHT LEFT RIGHT LEFT
REAR LS FRONT LS
CENTRE LS
Connect a good quality stereo RCA phono lead to the L and R inputs on
the 2070Si and connect the other end to the PRE OUT sockets on the rear
of the amplifier.
The subwoofer will automatically add the L and R signals together so that
no information is missed. If you wish to use two subwoofers then you can
run a single RCA phono cable to each subwoofer and thus have a stereo
sub-woofer system.
Ensure that the L output on the amplifier goes to the left hand side sub-
woofer and R to the right hand side to preserve the stereo image of the
main speakers. The subwoofers will need to be placed close to their
respective main speakers and the set-up will need to be done separately
for each sub-woofer.
SUBWOOFER
LINE
IN
PRE OUT
LEFT /
MONO
L R
IN
RIGHT