Regulations And Standards - Tractel guard trac Manual De Instalación, De Operación Y De Mantenimiento

8. To install the guard trac™ or guard trac™
plus guardrail in any way other than the one
described in this manual.
9. To use the guard trac™ or guard trac™
plus guardrail if one or more 25Kg counter-
weights are not in place on the bracket and
correctly placed.
10. To install the guard trac™ or guard trac™
plus guardrail on any waterproof surface
other than the ones described in this man-
ual.
11. To install the guard trac™ or guard trac™
plus guardrail on any surfaces with a slope
bigger than 10°.
12. To use the guard trac™ or guard trac™ plus
guardrail if it is located less than 50 mm from
the existing parapet
13. To install the guard trac™ or guard trac™
plus without a toe board in a zone without a
parapet of at least 150mm.
DANGER: In cases where there is no
parapet or where this is less than 150
mm high, the guard trac™ t-b barrier
should be used.
14. To use the guard trac™ or guard trac™ plus
guardrail that has arrested a falling person
or object and not been put back into use ac-
cording to this manual.
15. To use the guard trac™ or guard trac™ plus
guardrail in an explosive atmosphere.
16. To use the guard trac™ or guard trac™ plus
guardrail in a highly corrosive atmosphere.
17. To use the guard trac™ or guard trac™ plus
guardrail outside a temperature range of be-
tween -30 °C and +60 °C,
18. To use the guard trac™ or guard trac™ plus
guardrail as an anchor point.
19. To use the guard trac™ or guard trac™ plus
guardrail for hanging tools.
20. To place an interface between the 25 kg
counterweight and the roof sealant during
installation,
21. To install the guard trac™ or guard trac™
plus guardrail on a roof surface that has not
been previously cleared and cleaned,
22. To carry out repairs on the guard trac™ or
guard trac™ plus guardrail.
23. To install or use the guard trac™ or guard
trac™ plus guardrail if you are not fit and
healthy, both physically and mentally.
24. To install or use of the guard trac™ or guard
trac™ plus guardrail if a rescue plan has not
been prepared previously in the event of an
operator fall.
25. To use the guard trac™ or guard trac™ plus
guardrail if the installation surface is con-
taminated with grease, oil, foam, algae or
any other product that might facilitate sliding
on the roof sealant.
26. To install the guardrail gate so that the open-
ing direction is outside the safety zone.
27. To use the guard trac™ or guard trac™ plus
guardrail if the locking pins on the adjustable
barriers are not correctly located.
28. To use the guard trac™ or guard trac™
plus guardrail if the barriers are not properly
locked into their position inside the brackets.
29. To use the guard trac™ or guard trac™ plus
gate if the locking and gate length adjust-
ment handles are not firmly tightened.
30. To use the guard trac™ or guard trac™ plus
guardrail if the inter-barrier clamp is not firm-
ly tightened onto the uprights of the adjacent
barriers.
31. To use the guard trac™ or guard trac™ plus
guardrail if the opening between the end
guardrail and other structures is greater
than 120 mm.
32. To carry out modifications on the guard
trac™ or guard trac™ plus guardrail.
33. To use parts and components other than
those supplied by Tractel®
34. To use the guard trac™ or guard trac™ plus
guardrail as an anchor point for PPE (per-
sonal protection equipment)
35. To use the single bracket for the uprights of
barriers next to the gate.
36. Load the toe board

10. Regulations and standards

Tractel® Ibérica S.A. Crta. Del Medio, 265
08907 L'Hospitalet de Llobregat (Spain), hereby
declares that:
– The guard trac™ and guard trac™ t-b guard-
rail is EN13374-A of June 2019 certified.
– The guard trac™ plus guardrail is certified
according to European Standard EN 13374-
A of June 2019 and the international stan-
dard ISO 14122-3 of March 2016.
This equipment has been type tested by a no-
tified body: DEKRA Testing and Certification
GmbH – 44809 Bochum, Germany.
GB
21