Kohler K-T16225 Guia De Instalacion página 8

Valve Stem
Backing
Plate Tab
5. Install the Valve Trim
NOTICE: For K-306-KS valve: The thin wall installation kit (88526)
is required for fiberglass or acrylic installations.
NOTE: The handle assembly illustrated may not represent your
actual product. The installation instructions still apply.
For installation over a tiled wall, apply a bead of silicone sealant
around the back edges of the escutcheon.
Break off the tab at the lower right on the backing plate. Fit the
backing plate over the valve so the large hole is on the bottom
and secure with two screws. Do not overtighten.
Rotate the valve stem fully counterclockwise.
Position the escutcheon over the backing plate and thread the
collar into the backing plate. Do not cross thread.
Insert the sleeve into the notches of the collar and hand tighten. If
the collar does not thread into the backing plate, thread the
backing plate screws 1/2 turn back.
Turn the sleeve around so the cutout in the sleeve faces away
from the wall.
Place the handle assembly over the valve stem and tighten the set
screw.
1059598-2-C
Screws
Handle
Assembly
Escutcheon
8
Collar
Sleeve
Setscrew
Kohler Co.