Omega MagicLift 25030B Manual De Piezas E Instrucciones De Funcionamiento página 3

WARNING
!
• Study, understand, and follow all instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Lifting device only. Immediately after lifting,
support the vehicle with appropriate means.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• Do not move or dolly the vehicle while on the
jack.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
PREPARATION/ASSEMBLY
Before Use
1. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product and its components, and recognize the hazards associated with its use.
2. Verify that the product and application are compatible.
3. Assemble the 2-piece handle with provided screws.
4. Always secure the handle into the handle fork by means of the bolt and lock washer provided. Tighten securely
to prevent accidental removal of handle while in use.
WARNING: Do not lift or carry jack by handle. Handle could dislodge and jack fall, resulting in possible injury
!
or property damage.
5. To familiarize yourself with basic operation, locate and turn the release valve (pump handle):
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the saddle.
b. Counter-clockwise, but no more than 1/2 turn from the closed position. This is the 'OPEN' release valve position
used to lower the saddle.
6. With saddle fully lowered and release valve closed, pump the handle. If lift arm responds immediately, jack is
ready for use. If jack does not respond, follow Bleeding/Venting Trapped Air instruction below. Check oil level.
7. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the entire lifting range before
putting into service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with
authorized replacement parts only.
Bleeding/Venting Trapped Air
With the release valve in the OPEN position (step 5b. above) and with saddle fully lowered, locate and remove the
oil filler plug. Pump handle 6 to 8 full strokes. This will help release pressurized air which may be trapped within
the reservoir. Reinstall the oil filler plug and check operation.
WARNING
!
To avoid crushing and related injuries:
• Never work on, under or around a load supported
only by hydraulic jack.
• Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support
nor move a house, mobile home, travel trailer,
camper or any building structure.
• Be alert and sober when using this product. Do
not operate under the influence of drugs or
alcohol.
3
X