Tabla de contenido
Idiomas disponibles
Idiomas disponibles
14
14B
14A
14G
14A
14 FAUCET PREPARATION
From underneath faucet, remove Nut (14A) from Mounting Post (14B). Remove Putty
Plate (14C) and Deck Plate (14D) from Faucet Body (14F). Assemble Mounting Ring
(14E) and Putty Ring (14G) to Faucet Body (14F). Secure by placing and threading Nut
(14A) onto Mounting Post (14B).
15
15A
15B
15 FAUCET INSTALLATION
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in Putty Ring (15A). Insert the faucet Supply Tubes (15B) through the center
hole of the sink.
16
16A
16B
16C
16 SECURING FAUCET TO DECK
Remove any excess putty from around the outside edge of Mounting Ring (16A). From
underneath sink, secure the faucet by placing the Metal Washer (16B) and the Long
7
Nut (
/
Hex.) (16C) onto the Mounting Post (16D). Make sure that the bumps on the
16
Metal Washer (16B) are facing up. Tighten until the faucet is firmly connected to the
sink. Do not over tighten!
14F
14D
14C
14E
14F
14B
16D
ENGLISH
17
Water Supply Lines are not included. Please consult
manufacturer and/or its instructions for the correct
method of installation of supply lines and fittings.
CAUTION: Incorrect application of supply lines and fittings may
result in the failure or leak of the supply lines and fittings.
B
17C
1" Max.
(26 mm)
HOT
C
17D
17E
17B
17 WATER SUPPLY CONNECTIONS
A.
Thread Inlet Connectors (17A) into Water Supply Lines (17B).
B.
Remove Protective Cap (17F). Gently separate hot and cold Faucet Inlets (17C),
approximately 1 in. (26 mm) apart. Connect Water Supply Lines (17B) onto Faucet Inlets
(10C). Hot water supply line goes to hot inlet fitting indicated by red tag.
C.
Insert Clip (17D) into Inlet Connector Holes (17E) to secure water supply lines, as
shown.
5
A
17A
17B
17C
17C
17A
17B
COLD
17D
17C
17F
17A
17B
Tabla de contenido
