Idiomas disponibles
Idiomas disponibles
Assembly Instructions
Estimated Assembly Time: Approximately 20 minutes
Note: Assemble basin on a level surface.
Make certain all connections are secure.
1. Route power cord through notch at bottom of basin (A).
2. Place second basin (C) upside down on ground.
3. Insert upper end of bottom pole (B) into bottom of second basin.
4. Insert lower end of bottom pole into upper end of basin.
5. Place third basin (E) upside down on ground.
6. Insert upper end of middle pole (D) into bottom end of third basin.
7. PVC tube (H) is attached to the fountain upright (F). Route PVC tube
(H) through hole of third basin and middle pole.
8. Insert lower end of fountain upright into upper end of third basin.
9. Insert lower end of middle pole into upper end of second basin.
10. Route PVC tube through hole of second basin and into pump house in
basin.
11. Connect PVC tube to pump outlet.
12. Place cover (I) over pump compartment.
13. Fill basin with clean water. Note: The water level should be
approximately 1 inch below basin's edge.
14. Add water to second and third basins. Note: Water levels should be at
bottom of drain holes in each basin.
15. Connect plug to a proper power source. Product should start working.
Note: See troubleshooting section if water does not flow.
Troubleshooting Guide
Problem
Pump operates, but there is no
water flow.
Pump operates, but there is no
water flow and pump is fully
submerged and supply tubing has
no kinks.
SAVE THESE INSTRUCTIONS!
Note: Each Garden Treasures fountain product may have variations in texture, finish and appearance from unit to unit. This enhances the beauty of the
product and makes each Garden Treasures fountain product unique. Some products and finishes are intentionally weathered or worn in appearance for
aesthetic design.
1- Year Limited Warranty
(Valid in USA and Canada only)
Peaktop warrants this product to be free from defect in material and workmanship for a period of one year from the date of original retail purchase and
as set forth below.
Repair/ Replacement Warranty: Pursuant to this Limited Warranty, Peaktop will, at its option,(i) repair the product using new or refurbished parts or (ii)
Remedy
1. Make certain pump is fully submerged.
2. Make certain supply tubing has no kinks.
1. Remove supply tubing from pump outlet.
2. Clean tube.
3. Set pump in water (outlet side up).
4. Once water begins to flow, reattach supply tubing.
2
Cover
NOTE: Diagram shown is for illustrative purposes only.
