Emptying The Dust Cup; Replacing Filters - Shark Navigator Pet ZU60 Serie Guia Del Usuario

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, slide up the latch on top of
dust cup handle. Tilt dust cup forward, then
lift to remove.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
s h a r kc l e a n . c o m
Press lower release button to open bottom of
dust cup.
To reinstall, place bottom of dust cup into
pod and then tilt back until it clicks into place.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
To prevent damage from cleaning chemicals rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Felt
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.

REPLACING FILTERS

Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
Replacement
Pre-Motor Foam &
Felt Filter Kit
1239FT60
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
HEPA
Filter
Filter
Door
CLEAN HEPA FILTER
EVERY YEAR
Press down top of Filter Door. Tilt Filter
Door and lift out. Press tab at top of HEPA
Filter and pull away from the base of the
vacuum. To reinstall, insert HEPA filter into
unit and replace the filter door.
Replacement
HEPA Filter
1238FT60
s h a r kc l e a n . c o m