Allmatic CT ACTION 09 Guia De Instalacion página 13

página de 41

/ 41
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

4.6 Automatic re-closing adjusting

This procedure must be carried out ONLY by the installer and ONLY during the setting up of the system.

For a correct programming, before to carrying out any modification, bring always the system in totally closed position (see section 4.2).

Give a step by step order with

automation closed and wait the

complete opening.

Automatic reclosing disabling

Rotate the AUTOMATIC RECLOSING trimmer completely in clockwise

sense. Like this the automatic reclosing is disabled.

Automatic re-closing by photocells

Rotate the AUTOMATIC reclosing trimmer completely in anticlockwise

sense to enable the automatic re-closing by photocells. If the photo-

cells' beam is not interrupted, the control unit recloses after 4 minutes.

WARNING: the automatic re-closing is deactivated if during the closure the intervention of the anti

– squashing sensor happens and the consequent re-opening.

4.7 Re-synchronization

This operation must be carried out ONLY in case you observe repeatedly that the gate does not reach the correct position of closure (or if it tends

to overstep it), or if you find in the conditions described on point 4.8.

The re – synchronization operation consists on the activation in closing of the gate at reduced velocity with the aim to find the point of total closure;

the movement stops itself automatically in the point in which a mechanical stop which obstacles the movement.

Such position is identified as closing position.

Press the first key of the transmitter for a time superior than

6 seconds, then release it.

The gate stops itself temporarily (if in movement), then it

starts again at reduced velocity.

Release the key.

The gate stops itself at the presence of a mechanical stop

memorizing in such as point the close position.

WARNING: during the operation of re – synchronization the intervention of the anti – squashing security is interpreted as identification

of the closing position. To avoid its involuntary intervention the sensitivity of the same results remarkably reduced respect to the normal

condition of functioning.

4.8 Gate unlocking

In case of opening of the gate with inserted lock, it is the intervention of the security which involves the stop of the gate.

In this case it is possible that the lock remains locked cause of the tension exercised by the gate. If this happens it is advisable to resort the re-

synchronizing operation (point 4.7).

4.9 Belt tension adjusting

For an optimal functioning of the control unit and particularly of the anti – squashing security, it is necessary the adjusting of the belt transmitting

the movement.

The adjusting must be carried out in such a way as, during the re-synchronization phase (point 4.7) with trimmer for adjusting the force in position

of normal utilization, the belt does not present slipping or rather making sure that it does not come out from its seat

6-1622356 rev.4 09-07-2013

Rotate the AUTOMATIC RECLOSING trimmer in clockwise sense.

Like this the automatic reclosing time increases.

The automatic reclosing

time is too short.

The automatic reclosing

time is too large.

Rotate the AUTOMATIC RECLOSING trimmer in anti – clockwise

sense. Like this the automatic reclosing time decreases.