Compressed Air For Plasma And Cooling Gas - Abicor Binzel ABIPLAS CUT 200 W Instructivo De Servicio

®
ABIPLAS CUT 200 W/MT

6.3.1 Compressed air for plasma and cooling gas

1
1 Coolant return hose
Fig. 6 Connecting the coolant
Bleed the entire cooling system as follows when used for the first time and after
every cable assembly replacement:
1 Disconnect the coolant return hose (1) from the coolant recirculator (2) and
hold it over a collecting device.
2 Close the opening on the coolant return hose (1) and then re-open it by
abruptly releasing it. Repeat this process until the coolant flows into the
collecting device continuously and without air bubbles.
3 Switch off the coolant recirculator (2) and re-connect the coolant return
hose (1).
• Precise adjustment of the compressed air pressure and flow/volume are
important for igniting the pilot arc, the quality of cut and the service life of
the torch and wear parts.
 Tab. 3 Product-specific torch data (EN 60 974-7) on page EN-8
6 Putting into operation
2 Coolant recirculator
2
EN - 17