Festo SFC−-LA Instrucciones Breves página 24

5 Menu structure (control panel)
Menu
command
Diagnostic
Pos. set table
Axis param
System param
SW information
1) 2)
Positioning
Homing
Move posit set
Demo posit tab
1) 2)
Settings
Axis type
Axis parameter
Homing paramet. Homing method g p
24
Description
Display system data + current settings
Display position set table
Display axis parameters and data
Display system parameters and data
Display operating system version (firmware)
Reference travel and positioning runs for testing the position sets
Start reference travel
Start positioning travel Position set"
Start positioning travel Pos. set table"
Select the drive, parametrizing, programming the position sets
HME−...
3) 4)
Zero point
3) 4)
SW−limit−neg
3) 4)
SW−limit−pos
Tool load
SAVE...
Velocity v_rp
Velocity v_zp
SAVE...
1)
4)
4)
Linear module type HME−...
Offset of the axis zero point AZ to the
reference point
Software end position, negative; related to AZ
Software end position, positive; related to AZ
Tool mass (e. g. gripper)
Save parameters in EEPROM
Select referencing method
Positioning speed for searching for the
reference point
Positioning speed for moving to the axis zero
point
Save parameters in EEPROM
Festo P.BE−K−SFC−LAC−IO 0604NH English