Important - Bissell SpotClean 5207 Serie Manual Del Usuario

Operations
Pre-treating
Cleaning effectiveness will be enhanced if you
pre-treat heavily stained or highly soiled areas.
Here's how to do it:
1. Hold the 3" Tough Stain Tool just above the
carpet or upholstery to be cleaned. Press the
trigger to mist solution over the soiled area. For
Deep Stain & 3-N-1 Stair Tool, follow instructions
on page 6 & 7
2. Wait 3-5 minutes before cleaning.
Cleaning with the Tough Stain Tool
1. Attach the 3" Tough Stain Tool to the handheld
cleaning hose.
2. Plug in the unit and press the power button
beneath the handle to turn it on.
3. Hold the tool 1 inch above soiled surface.
4. Press the spray trigger to mist solution over
and onto the soiled area.
5. Release the spray trigger and gently scrub the
stain.
6. To lift the stain away, apply downward
pressure on the tool and slowly pull it toward
you. Watch as powerful suction removes the
dirt and cleaning solution. Continue until no
more dirt can be removed.
7. As a final step, use "drying strokes" (by not
pressing the spray trigger) to remove as much
moisture as possible. Repeat this step as often
as necessary.
NOTE: Oxy Boost formula will continue to clean
oxidizable stains for 6-8 hours.
www.BISSELL.com
6
WARNING
Keep spray away from face. Failure to do
so may result in personal injury.

IMPORTANT

Check the manufacturer's tag before
cleaning upholstery. "W" or "WS" on the tag
means you can use your SpotClean. If tag
is coded with an "S" (with diagonal strike-
through), or says "Dry Clean Only," do not
proceed. If manufacturer's tag is missing or
not coded, check with your furniture dealer.