SATA AE1017H Instrucciones De Uso página 47

4.2.11
Remove the vertical cap while supporting the vertical shaft to prevent it from slipping and causing personal
injury or damage to the machine.
4.2.12
4.2.13 Installation of air source triplet
AE1017H
中文
EN DE RU
Remove the internal hexagonal screws on
the vertical cap with a #8 internal hexagonal
wrench as shown in Fig. 4-8, then install the
vertical spring in the hexagonal shaft and refit
the vertical cap to the hexagonal shaft.
Fig. 4-8
Install the push-pull arm guard: take out the
protective cover and mounting screws from
the accessory box and install the protective
cover onto the hexagonal shaft (Fig. 4-9). Insert
the half-round head screws in the outside of
the protective cover, fit the fixing sleeve and fix
the screws inside the mounting hole.
Fig. 4-9
First take out the air source connector (Fig.
4-10) from the accessory box and install it at
the intake end of the air source triplet (Fig. 4-11),
then fit the quick connector of the air source
into the air source connector.
Note: The air supply shall must be cut off
during the installation of the air source.
Fig. 4-10
KO PT JA ES
47