Safety Rules - Würth master VARIO DRILL 90 Instrucciones Para El Manejo

VARIO DRILL 90
GB
Operating Instructions
Your VARIO DRILL 90 is a high-capacity compressed-
air gun for the removal of welding spots.
For safe operation, the following precautions should be
taken:

Safety rules

The following safety measures should always be taken,
regardless of any additional safety or accident-prevention
rules which might be applicable in each country:
Do not use your VARIO DRILL for purposes other
than the removal of spot-welded joints from sheet-
metal structures.
Disconnect compressed-air supply when changing
from one bit to another (VARIO MATIC or cutter).
Wear goggles and protective gloves when working
with your VARIO DRILL.
Never point your VARIO DRILL at yourself or any
other person.
The valued sound pressure level of the VARIO DRILL
is typically 84 dB. The sound level while working with it
may be in excess of such value; therefore, it is recom-
mended to wear ear plugs.
Check cutter blades and tips for breaks or wear.
If necessary, change cutter tool.
To reduce the risk of breaking to a minimum, do not
use cutter tools other than the genuine VARIO DRILL cutters.
Never hold workpieces in your hand, but have them
clamped instead or make sure their own weight holds
them down to give the correct support.
If you wear long hair, you should use an appropriate
hair protection.
Make sure your VARIO DRILL is completely dis-
connected when cleaning or greasing it.
Protect the machine against falling down. Do not drop
the machine.
Your VARIO DRILL is not insulated against contact
with electric current !
Do not use your VARIO DRILL in an atmosphere
where there is the risk of explosion!
The maximum operating pressure is 8 bar!
Putting the VARIO DIRLL into operation
Refer to the above safety rules and read them carefully
before putting the VARIO DRILL into operation.
Use clean, dry air only. The use of a compressed-air
valuation unit is recommended.
Air operating pressure: 6 – 8 bar.
Hose diameter: superior to 6 mm.
Pour a few droplets of lightweight nonresinous oil into
the compressed-air mouthpiece
If not yet assembled, screw an appropriate air connec-
tion (1/4") onto the air-volume reducing valve
Important: Tighten screw
VARIO DRILL into operation for the first time, tighten
again from time to time. Make sure your VARIO DRILL
is disconnected from the compressed-air supply
during such operation.
4
every day.
13
12
.
before putting your
Hints on the different uses of your
VARIO DRILL
Recommended speed of special VARIO DRILL Cutter:
with VARIO MATIC about 1,000 UPM
without VARIO MATIC about 1,300 UPM
Speed adjustment is on the air-volume reducing
valve 12 .
Use your VARIO DRILL with VARIO MATIC (Fig. 1) to
readily remove external welding spots on edges, sec-
tional shapes, notches.
1
Use your VARIO DRILL without VARIO MATIC
(Fig. 2) to readily remove internal, concealed welding
spots or those where access is difficult.
ATTENTION: Press your VARIO DRILL firmly against
the welding spot before switching it on. The cutter
tip and the depth stop
sideslipping. Never use your VARIO DRILL with a
broken cutter tip.
To dismount the
VARIO MATIC,
open ring and
A
remove it from its
locking hook .
B
prevent the machine from
2
3