32. Press Y button to continue and wait until the
"Operation Done!" message shows:
If the operation is not carried out successfully, an "Operation Failed!" message shows.
Repeat the process to try again.
33. Press any key or wait a few seconds to return.
Inspect Brake Air
If brake system fails, only the front wheels are braked via a separate hydraulic circuit without brake
servo assistance. The Inspect Brake Air is to ensure that no air is present in the separate hydraulic
circuit. Important: Do not operate the pedal until you are prompted to do; otherwise the service may
not be completed.
1. Use UP/DOWN button to select Inspect Brake
Air from Select Function menu and press Y button
to confirm.
2. View onscreen prompts and press Y button to
continue.
3. Follow onscreen instructions to finish the first phase of operation:
- Pressure reservoir: check pretension pressure.
- Actuation takes about 30s.
4. Press Y button or gently actuate and then release the brake pedal to continue. If you do not wish to
continue, press N button to exit and a "User Aborted!" message comes up. You can exit the air
inspection service at any phase of the operation with N button.
5. Wait a few seconds while the device is communicating with the vehicle.
And follow onscreen instructions to finish the second phase of operation:
- The brake system pressure reservoir is OK.
- Check fill status of rear wheel brake circuits.
6. Press Y button or gently actuate and then release the brake pedal as instructed to continue.
7. Wait a few seconds while the device is communicating with the vehicle.
And follow onscreen instructions to finish the third phase of operation:
- Brake system fill status is OK.
- Check fill status of pedal travel simulator.
8. Press Y button or gently actuate and then release the brake pedal as instructed to continue.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
15
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed