Saivod STE 6 Manual Del Usuario página 12

6
Solution suggestions for problems
Problem
Drying process takes
too much time.
Laundry come out wet
at the end of drying.
Machine does not
switch on or the
program does not
start. Machine is not
activated when set.
Program has been
interrupted without
any cause.
Laundry has shrunk,
become felted or
deteriorated.
Drum lightning does
not come on.
(for models equipped
with a lamp)
"Final / Anti-creasing"
LED flashes.
"Final / Anti-creasing"
LED is on.
The "Drying" LED
flashes.
Also for products equipped with a condenser
"Water tank" warning
LED is on.
"Filter cleaning" LED
is on.
"Condenser cleaning"
LED is on.
A
Call an authorized service if the problem persists.
Cause
Cover filter and filter drawer might have
not been cleaned.
* Cover filter and filter drawer might
have not been cleaned.
* Excessive laundry might have been
loaded in.
* It might have not been plugged in.
* The loading door may be ajar.
* Program might have not been set or
the "Start/Pause/Cancel" button might
have not been pressed.
* "Childproof lock" might have been
activated.
* The condenser cover on the models
with a condenser might not be closed
securely.
* The loading door may be ajar.
* Electricity may be cut off.
* A program suitable for the laundry
type might have not been used.
* The machine might have not been
started by using the On/Off button.
* Bulb may have blown.
* The 2-hour anti creasing program to
prevent laundry from creasing might
have been activated.
* Program has come to an end.
* A heat sensor failure has occurred.
Machine ends the program without
heating.
* Water may be full.
* Anti-creasing program might be
running.
* Filter might have not been cleaned.
* Filter drawer/Condenser might have
not been cleaned.
Explanation / Suggestion
* Clean the cover filter and Filter drawer.
* Clean the cover filter and Filter drawer.
* Do not overload the machine.
* Make sure that the machine is plugged
in.
* Make sure that the loading door is
properly closed.
* Make sure that the program has been
set and it is not in "Pause" mode.
* Deactivate the childproof lock.
* Make sure that the condenser cover
and the red lock is closed securely.
* Make sure that the loading door is
properly closed.
* Press "Start/Pause/Cancel" button to
start the program.
* Dry only the laundry which is suitable
for drying in your machine after checking
the labels on your clothes.
* Select a program with suitable low
temperature for the laundry type to dry
your clothes.
* Make sure that the machine is On.
* Call the authorized service to replace
the bulb.
* Turn off the machine and take out the
laundry.
* Turn off the machine and take out the
laundry.
* Turn off the machine and take out the
laundry. Call your authorized service.
* Drain the water in the water tank.
* Clean the cover filter.
* Clean the filters in the condenser/filter
drawer under the kick plate.
12 - EN