Krups XP4050 Instrucciones De Uso página 8

illy  is a registered trademark of illy espresso of
the americas, inc.
Starbucks  is a registered trademark of the
Starbucks Coffee Company
2. P
ROGRAMMING YOUR MACHINE
Should you wish to alter the preprogrammed
quantity (50ml per cup, manufacturing set-
ting) of espresso filled into one or two cups,
proceed as follows:
• Fill the water container (1) (2) (3) and turn
on the machine (4).
• Put the filter basket for one or two cups
into the filter holder (5).
• Place some ground coffee in the filter
basket (1 or 2 measuring scoops). Do Not
Tamp the coffee into the coffee filter. Fill
the ground coffee to the top of the filter
handle and use the flat end of the measu-
ring spoon to Polish the top of the coffee
but do not tamp or compress the ground
coffee into the filter.
• Remove any ground coffee from around
the top rim of the filter handle to create a
good seal to the brewing head.
• Replace the filter holder (6) (7).
• Place one or two cups beneath the filter
holder.
As soon as the coffee selection buttons
begin to glow continuously, the machine is
ready to operate.
• Hold down either the one or two cups
button or (9) (10) (>3 sec). The
coffee button and start/stop switch will
begin to blink.
• When the desired quantity of espresso has
run through, stop the machine by pressing
the coffee button
The quantity that just ran through into your
cup is now automatically programmed into
the machine.
3 . H W P
OT ATER REPARATION
You can prepare hot water with this
machine.
• Fill the water container (1) (2) (3) and turn
on the machine (4).
• Place the cup beneath the auto cappuc-
cino accessory.
.
:
or
(9) (10).
As soon as hot water button commences to
glow continuously, the machine is ready to
operate.
• Press the hot water button
• When the desired quantity of water has
run through, stop the machine by pressing
again the hot water button
• Put the filter holder with the empty filter
in place (6) (7) and push the brew button
to purge and clean the filter of coffee
sediment.
4. S
TEAM FUNCTION FOR PREPARING
CAPPUCCINO AND LATTE
The thumping noise which occurs while
steam is being produced comes from the in-
termittent regulation of the pump and has no
effect on the proper working of the machine.
If you wish to make an espresso imme-
diately after steaming milk, the machine
must first be allowed to cool down in order
to achieve the correct temperature required
to prepare an espresso.
• As soon as you interrupt the steam cycle,
the appliance will cool down automatically
by launching an intermittent pump cycle
for 40 seconds. The cold water pumped
through will cool down the heating system.
During the cool down phase, the blue
start/stop operating control light blinks and
the hot water flows into the drip tray. When
the correct temperature is reached, the
appliance is ready.
Caution: during and after use of the ma-
chine, the metallic parts of the auto cappuc-
cino accessory can become extremly hot.
It is best to use fresh, skim or low-fat, well
chilled milk. The milk container must also be
cold (do not run it under hot water before
frothing the milk).
. Using the Auto Cappuccino accessory
The auto cappuccino accessory makes
it easy to produce steamed frothy milk
for making cappuccino, latte or even hot
chocolate.
• Fill the water container with fresh, cold
water (1) (2) (3) and turn on the machine
(4).
(14).
(14).
11