Idiomas disponibles
Idiomas disponibles
INSTALLATION AND SERVICE INSTRUCTIONS FOR FEDERAL MODELS FB24STHI
FIREBALL® VISUAL SIGNAL APPLIANCES FOR THE HEARING IMPAIRED
It is important to follow all instructions shipped with this product. This device is to be
installed by a trained electrician who is thoroughly familiar with and will follow all
applicable national and local codes in the country of use.
This device should be considered a part of the warning system and not the entire
warning system.
The selection of the mounting location for the device, its controls and the routing of the
wiring is to be accomplished under the direction of the facilities engineer and the safety
engineer. In addition, listed below are some other important safety instructions and
precautions you should follow:
•
Read and understand all instructions before installing or operating this
equipment.
•
Never alter the unit in any manner. Safety may be compromised if additional
openings or other alterations are made to the unit.
•
Do not connect this light to the system when power is on.
•
After installation, ensure that the set screw and threaded joints are properly
tightened.
•
Keep unit tightly closed when in operation.
•
After testing is complete, provide a copy of this instruction sheet to all
operating personnel.
•
Establish a procedure to routinely check the light installation for integrity
and proper operation.
Failure to follow all safety precautions and instructions may result in property damage,
serious injury, or death to you or others.
I.
GENERAL.
The Model FB24STHI strobe light is a Visual Signaling Appliance for the Hearing
Impaired for indoor use on a wall or ceiling in a nonsleeping area. In addition, the Model
FB24STHI complies with the TYPE 4X (watertight and corrosion resistant) and IP66 (dust-
tight and heavy seas) enclosure requirements.
For the Electrical Ratings and Light Dispersion Pattern of the Model FB24STHI,
reference Table 1 and Figure 1.
II.
INSTALLATION.
A.
Unpacking.
After unpacking the unit, examine it for damage that may have occurred in
transit. If the equipment has been damaged, do not attempt to install or operate the unit.
File a claim immediately with the carrier, stating the extent of damage. Carefully check all
envelopes, shipping labels and tags before removing or destroying them.
SAFETY MESSAGE TO INSTALLERS,
USERS AND MAINTENANCE PERSONNEL
-1-
