Campbell Hausfeld HL4330 Manual De Instrucciones página 9

specifications
EXTENSION CORD INSTRUCTIONS
1. The air compressor should be located where it can be directly plugged into an outlet. Although extension cord
is not recommended, if you must use only a 3 wire extension cord that has a 3 blade grounding plug and a 3 slot
receptacle that accepts the plug on the product. When using an extension cord be sure to use one heavy enough
to carry the current the product draws.
2. To avoid loss of power and overheating, additional air hose must be used to reach work area instead of
extension cords.
PLUG AND RECEPTACLE INSTRUCTIONS
Figure 3
2. Make sure that the product is connected to an outlet having the same configuration as the plug.
3. The receptacles must be connected to circuits rated to carry at least the voltage and amperages shown.
4. NEVER have a receptacle replaced with one of a higher amperage before determining the change can be made
according to all electrical codes affecting your particular area. The installation should be made by a qualified electrician.
If the products must be reconnected for use on different types of circuits, the re-connection should be made by qualified
personnel.
assembly
HARDWARE REQUIRED FOR ASSEMBLY AND USE (NOT INCLUDED)
110-120 VOLT, 60HZ INFORMATION: The plug supplied on your
compressor may not fit into the outlet you are planning to use.
Your local electrical code may require slightly different power cord
plug connections. If these differences exist refer to and make the
proper adjustments per your local code before your compressor is
plugged in and turned on.
1. If the plug on the electrical cord of the unit is unfamiliar to you or will
not fit your particular receptacle, Figure 3 will help you understand why
by illustrating the different plugs and the voltages they are to be used
with.
Overheating, short circuiting and fi re damage will result from inadequate wiring.
Hose
Purchase a hose that has a minimum rating of 175 psi
and exceeds the maximum working pressure of the
compressor.
• If you lose an accessory and want to purchase a
replacement, contact the Campbell Hausfeld service
center (1-800-543-6400).
• The design of the parts and accessories may differ
from the images shown; their design is subject to change
without notice for product improvement.
9