Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The detection sensitivity can be adjusted,
according to the usage conditions.
The movement can be also detected in low
lighting conditions.
The detection range reaches a maximum of 12
meters in optimum conditions.
Now, get close to the area where the MOTION will be installed, just to validate the signal, and
switch it on by pressing the B1 button.
For the day basis working situations, the indicator flashes red whenever it detects movement.
Fasten the base to the wall, respecting a height of 2-2,2meters. Make sure that you do not
place it in an area affected by a direct source of heat/cold, for not affecting the correct
temperature indication. Do not direct it to doors and windows that could receive direct light,
to avoid a false detection effect.
For security reasons, it is recommended to fasten the device using the crews included.
The led indicator will flash red and green
once, then green for five times and green
again for six more times in case it connects
correctly to the GATE.
In case it does not follow the flashing
sequence correctly, make sure that the GATE
is
switched
on
and
requirements have been fulfilled.
If it has not worked, reset the device pressing
the B2 button for ten seconds. Keep pressing
until the flashing sequence ends. In case the
reset is correct, the led indicator will flash
green once and after a little while, green
quickly for 20 times, ending with a single red
flash.
16
that
the
signal
Tabla de contenido
