Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONTENTS
Part Qty.
1
2
Tilt adjustment knob
2
2
Rubber washer
3
1
Hex bolt M10 x 60mm L, zinc plated
4
2
Washer, 10mm, zinc plated
5
1
Spring washer
6
1
Nut
7
2
Expansion bolt
8
1
Wall hanger
9
1
Handle
10
2
Nut
Wall Mount Installation Instructions:
1. Install the unit at least 8 feet (2.4 m) away from the floor.
This minimum distance must be maintained.
2. Do not install closer than 1 foot (or 0.3 m) to any adjacent
vertical surfaces or walls.
3. Keep at least 4.5 inches (11.5 cm) from the back wall
(with or without using the wall hanging mounting bracket).
4. Determine the mounting location on the wall/ceiling and
mark the hole locations.
5. Use a 0.48 inch(12mm) drill bit and drill (2) holes 2.75
inches deep.
6. Insert the expansion bolts (7) flush to wall or ceiling.
7. Attach the mounting bracket (8) and secure with
expansion nut (10).
10
8
Note: The bracket must be firmly attached to the wall
before hanging the unit
8. Hook the unit to the mounting bracket and let the unit
hang from the mounting bracket.
9. Insert washer (4) and hex bolt (3) through mounting bracket
(8) and heater handle (9). Tighten with spring washer (5)
and nut (6).
5,6
3,4
Multiwatt Heater
Description
7.5 in
7
5,6
3,4
1
2
Wire Connection:
10. Run the electrical power supply cable in flexible
conduit and connect to the wiring compartment via
the round hole at back of the unit.
11. Connect the power supply wires (10 AWG) to the
pigtail leads of the unit in the wiring compartment.
Use wire crimps to make connections to corresponding
pigtail lead wires.
L1 Red L2 White Ground: Green
7.5 in
7
10
OPERATING INSTRUCTIONS HAZARD OF ELECTRIC
SHOCK, EXPLOSION OR ARC FLASH:
• Apply appropriate personal protective equipment
(PPE) and follow safe electrical work practices.
See NFPA 70
• Circuit breaker must be installed and serviced
only by qualified electrical personnel.
• Always use a properly rated voltage device to
confirm power is off.
• Confirm there are no materials near front or
rear of grills.
• Switch on the circuit breaker to turn on heater.
• Turn the switch to 1/2/3/4 position for heat selection.
Setting
0
1
1
2
3
4
2
3
Assembly Instructions
9
7
1
3
10
4
2
6
8
Round Hole
240VAC
208VAC
OFF
5000W
3785W
4165W
3131W
3335W
2508W
2500W
1881W
5
Pigtails
OFF
Tabla de contenido
