Programming For Audio - GE Universal RM24927 Instruccion Manual

Programming For Audio

This remote control will operate many fea-
tures found in audio/video receivers. The
remote control is already programmed to
operate most GE, RCA and ProScan brand
A/V receivers. Other brands of receivers
need to be set-up under the AUDIO button
prior to using the device.
1. Manually turn on the device you wish
to control. Find the three digit code for the
device you wish to control in the code list
below.
2. Press and hold the
CODE SEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release
the AUDIO button (The
INDICATOR LIGHT
will blink then remain
lit.
4. Enter the code using
the Number Buttons.
After your code is
entered, the INDICA-
TOR LIGHT will turn
off. If the code is not
valid, the INDICATOR
LIGHT will blink.
Check the code list and
repeat process.
5. Aim the remote at
the device you wish to
control and press the
ON•OFF button. The
device should turn off.
6. With your device
on, press VOL+ (Volume up). If the device
responds, no further programming is
required.
NOTE: If your device does not respond, try
all the codes for your brand. If the codes do
not work, or your brand is not listed, try the
Code Search method.
7. Enter your code and the type of device
SEARCH
AUDIO
1
4
7
AUDIO CODE
CD RCVR LD
10
CODE
INDICATOR
LIGHT
(BLINK)
2 3
5
6
(OFF)
8
9
0
ON•OFF
VOL