Connecting The Plasma-Cutting Torch - Abicor Binzel PSB Instructivo De Servicio

PSB
AUT PSB 60
6
1 Handle tube AUT
2
Electrode
Fig. 3 AUT PSB 60 and AUT PSB121

5.5 Connecting the plasma-cutting torch

5
3 Plasma nozzle ø1.0; 1.3; 1.5; 1.8; 2.0
4
Spring receiver
NOTICE
• Observe the correct assignment and tight fit of the connections.
• Since the plasma nozzle cannot be protected against direct contact for
technical reasons, it is necessary for the plasma cutting power source to
satisfy the requirements of EN 60974-7, Item 7.4.2.
• The plasma-cutting torch in connection with the plasma power source
must conform to EN 60974-10.
• Plasma power source must also be conform to EN 60974-1.
• The type of ignition (contact or HF) and the output (rated current and
corresponding duty cycle) of the plasma power source and of the cutting
torch must be identical.
 Tab. 3 on page EN-5
1
5 Electrode wrench
6
General purpose wrench
5 Putting into operation
AUT PSB 121
2
3
4
EN - 13