Skil PWRCORE 20 CS4562B-00 Manual Del Propietário página 35

Problem
Chain brake does not
engage.
Chain saw does not
cut properly.
Bar and chain run-
ning hot and
smoking.
Cause
1. Debris preventing full
movement of the chain
kickback brake handle.
2. Possible chain brake
malfunction.
1. Insufficient chain ten-
sion.
2. Dull chain.
3. Chain installed
backwards.
4. Worn chain.
5. Dry or excessively
stretched chain.
6. Chain not in bar
groove.
1. Check chain tension for
over-tightened
condition.
2. Chain oil tank is empty. 2. Fill the tank with bar and
3. Debris in guide bar
groove.
Remedy
1. Remove battery and clean
debris from external chain
brake mechanism.
2. Have the tool serviced
by an Authorized SKIL
Service Center or Service
Station.
1. Readjust the chain
tension, following the
section: "Adjusting the
Chain Tension".
2. Sharpen the chain
cutters, following the
section: "How to Sharp-
en the Cutters".
3. Reinstall the saw chain,
following the section:
"Replacing the Bar and
Chain".
4. Replace the chain,
following the section:
"Replacing the Bar and
Chain".
5. Check the oil level. Refill
the oil tank if necessary.
6. Reinstall the saw chain,
following the section:
"Replacing the Bar and
Chain".
1. Re-tension the saw chain;
see the section: "Adjusting
the Chain Tension".
chain lubricant.
3. Clear the debris in the
groove.
35