Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TABLETOP POWER STRIP ASSEMBLY
1. Choose desired location for power strip. Place two
supplied mounting clips roughly 32" apart (clip side
up). Using an electric drill, fasten to tabletop with
two supplied wood screws. (See Figure 25)
Figure 25
2. Secure power strip (15) by snapping into the
mounting clips. (See Figure 26)
MONITOR ARM ASSEMBLY
1.
Line up monitor arm mounting bracket (16) with
uprights at desired height.
2. Secure to uprights with two M6 x 35 mm or M6 x 50 mm
Allen head bolts, two small flat washers and two hex
nuts using an Allen wrench and 10 mm wrench.
(See Figure 27)
Figure 27
Allen Head
Bolts
Small Flat
Washers
PAGE 8 OF 27
OPTIONAL ACCESSORIES CONTINUED
Figure 26
ATTACHING MONITOR
NOTE: Make sure monitor has a VESA hole pattern
of 100 x 100 mm or 75 x 75 mm. (See Figure 28)
NOTE: If monitor is attached to a fixed base,
remove monitor from base.
CAUTION! Be careful not to scratch screen
during installation.
Figure 28
75 x 75 mm or
100 x 100 mm
1.
Easy-adjust monitor mount includes a built-in
counterweight system for free-range motion. Arm in
mount may need to be adjusted to allow monitor to
stop at desired position. Attach monitor to plate.
(See Figure 29)
Figure 29
Allen
Wrench
Use appropriate bolts for monitor.
2. To adjust the counterweight, use 5 x 5 Allen wrench
on screw above middle joint. Turn towards "–" if
monitor raises up. Turn towards "+" if monitor lowers.
Adjust until mount can be stopped at desired
position. (See Figure 30)
Figure 30
±180º -85º ~15º
Adjust swivel
with Allen
Wrench
Large Flat
Washer
Adjust Tilt with
Allen Wrench
±90º
±180º
0121 IH-5759
Tabla de contenido
