Cabinet Assembly - Uline H-5759 Manual Del Usuario

CABINET ASSEMBLY

NOTE: The cabinet and suspension have a 70 lb.
weight capacity.
1. Open the cabinet (8) door. Using a 7/16" wrench
and Phillips screwdriver, remove adjustable shelf by
unscrewing 4 screws.
ATTACHING TO NON-STEEL TOP
1. Using cabinet as a template, mark location of four
holes for wood screws onto underside of tabletop.
(Recommendation: 1/2" offset from front of table top).
2. Using 5/32" drill bit, drill holes into table top, drilling
about 1/2" to 3/4" deep.
3. Secure cabinet to underside of top, using four
#14-3/4" hex slotted wood screws. (See Figure 14)
NOTE: Cabinet can be flipped to have right or
left facing door.
4. Reinstall adjustable shelf and close cabinet door.
Figure 14
ATTACHING TO STEEL TOP
NOTE: Mounting channels are included with the
steel top. (See Figure 15) Channels may extend
past the cabinet assembly.
Figure 15
PAGE 6 OF 27
OPTIONAL ACCESSORIES CONTINUED
Mounting Channels
1. On the underside of the table, slide mounting
channels front to back into table flanges. When
channels are aligned, mounting holes should be
approximately 14⁄" apart. Secure each channel
with two 14⁄"-20 x 5/8" bolts.
2. Attach the cabinet to the mounting channels using
four 14⁄"-20 x 1/2" bolts. (See Figure 16)
NOTE: Cabinet door can be flipped to have
right or left facing door.
Figure 16
3. Close the cabinet door and turn the workstation
right side up. Reinstall adjustable shelf.
LIGHT KIT ASSEMBLY
1. Line up light brackets (10) with uprights at desired
height.
2. Secure to uprights with four 2" bolts and flange nuts.
(See Figure 17)
Flange
Nut
Bolt
Figure 17
0121 IH-5759