Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LEGS AND FRAME ASSEMBLY
1.
Insert adjustable feet (1) into legs (2) and slide into
place at desired height.
NOTE: If desired, insert locking tabs through
legs and adjustable feet to lock feet into place.
2. Place legs (2) in upright position. Legs should be
placed approximately 53" apart for 60" workstations
and 65" apart for 72" workstations. The 96" workstations
use three legs that should be placed 45" apart.
3. Attach stringer (3) to legs using center holes in back
of legs. Fasten using eight 1/4-20 x 5/8" bolts, lock
washers and nuts (12 bolts, lock washers and nuts
for the 96" workstation), but do not fully tighten.
4. Place lower shelf (4) across braces of legs. Attach
lower shelf using eight 1/4-20 x 5/8" bolts and nuts
(16 bolts and nuts for the 96" workstation). Now, fully
fasten hardware placed in step 3.
5. To attach tabletop (5) to frame assembly, place
tabletop on a smooth, non-marring surface with top
side facing down.
6. Rotate assembled frame upside down and line up
with pre-drilled pilot holes on the bottom side of
tabletop.
NON-STEEL/STAINLESS STEEL TOP ASSEMBLY
1.
Using six wood screws, attach leg to underside of
tabletop (5) through pre-drilled pilot holes. Only
insert screws into the front and center pre-drilled
pilot holes. Holes in the back should not be used at
this time. (See Figure 1)
FOR 96" WORKSTATIONS ONLY: For the center leg only,
insert two additional wood screws into the pre-drilled
pilot holes at the back of the table.
Do Not Insert
Screws
Tabletop
Figure 1
2. Using a 1/4" drill bit, drill four holes all the way through
tabletop in the pre-drilled pilot holes hole locations
shown in Figure 2. They should line up with the holes in
the back of the leg. (See Figure 2)
PAGE 2 OF 27
ASSEMBLY
FOR 96" WORKSTATIONS ONLY: Step 2 only applies to
the two ends of the table. The center leg is already fully
assembled and should not be drilled into.
3. Repeat steps 1 and 2 with other leg(s).
STEEL TOP ASSEMBLY
1. Align leg holes to end of tabletop. Secure with six
FOR 96" WORKSTATIONS ONLY: For the center leg only,
align leg with two holes in center of tabletop on each
end and secure with four 1/4-20 x 5/8" bolts, 1/4"-20
nuts and lock washer.
DRAWER ASSEMBLY
Wood
Screw
Front
NOTE: Use cobalt drill bit supplied with uprights
for stainless steel tops. This bit is specifically
designed to drill through stainless steel material.
NOTE: These holes are drilled to allow mounting
of uprights in later steps.
Back
Figure 2
1/4"-20 x 5/8" bolts per leg. Threaded inserts are
provided on each tabletop end. (See Figure 3)
Tabletop
Figure 3
2
#
DESCRIPTION
1
Drawer
2
Drawer Housing
3
Divider
4
Plastic Tray
Keys (Not Shown)
Hardware packet (Not Shown)
Front
4
3
1
QTY.
1
1
1
1
2
1
0121 IH-5759
Tabla de contenido
