Installation; Assembly - Vollrath BMA7103 Manual Del Operador

INSTALLATION

Countertop Installation
Install the Legs
NOTICE: If this equipment will be set onto a countertop, the
included legs must be installed.
Ensure that the equipment is level in all directions. Begin by tightening
each leg securely. Then, as needed at each corner, rotate the adjustable
foot.
Drop-in Installation
See the included Installation Instructions.
Record Your Serial Number
The serial number for your display case can be found on the rating plate
located on the lower right corner of the back of the case. To aid in future
communication about your product, please record the serial number in
the space below.
Serial Number

ASSEMBLY

Tools you will Need
• 8mm socket and wrench
• 10mm socket and wrench
2
• Nut driver
• Phillips head screwdriver
Attach the Glass Panels
Secure the Front Glass
1. Use two metal washers and one acorn nut to secure the front glass.
Hand tighten..
Curved Side Panels
1. Remove the top and bottom screws from the side of the side of the
upright. Retain the hardware.
2. Loosen, but do not remove the top and bottom screws from the back
of the upright.
3. Gently open the side upright to make space for the side panel glass.
Bain Marie Heated Display Case Operator's Manual