Adición de una interfase de cierre de interruptores
Paso 5
Seleccione el próximo canal
de entrada que desee
programar
Para asignar atenuadores, interruptores y
unidades de control GRAFIK Eye
canal de cierre, oprima y suelte el botón Input
Select hasta que se encienda el LED
correspondiente al canal deseado.
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the Lutron Technical Assistance
Hotline: 1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
18V
AC IN
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the Lutron Technical Assistance
Hotline: 1-800-523-9466
FCC ID JPZ0005
Patents Pending
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
18V
AC IN
Efectúe los pasos 3 y 4 para este nuevo canal
de entrada.
• Vaya al Paso 6 cuando termine de
programar todos los canales de entrada
en la interfase de cierre de interruptores.
3-9
Guía de Preparación del Sistema
a otro
®
Patents Pending
In ut 5
Paso 6
Complete la asignación de
atenuadores, interruptores y
unidades de control GRAFIK
Eye
a los canales de entrada
®
Oprima y sostenga los botones Program e
Input Select hasta que el LED Program (que
destella) se apague (aproximadamente 3
segundos).
In ut 5
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the Lutron Technical Assistance
Hotline: 1-800-523-9466
FCC ID JPZ0005
Patents Pending
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
18V
AC IN
Durante esta fase, todos los LED de Input
titilarán por breves segundos.
• Vaya a "Ajuste de la intensidad de luz/
Selección de Cuadro GRAFIK Eye
página 3-10.
",
®