Fitting The Bead Breaker Arm - Bosch TCE 4460 Manual Original

en 48 | TCE 4460 | Commissioning
4.2.5

Fitting the bead breaker arm

DANGER:
If the bead breaker arm is fitted incorrect-
ly, this affects the correct operation of the
machine and poses a serious risk to the
operator.
1. Remove the outer snap ring (A).
2. Remove the lower washer (B).
i
The upper snap ring remains in its position on the
pin.
3. Extract the rotating pin (C) from its position on the
bead breaker arm.
4. Remove the upper washer (D).
Fig. 20: Removing the rotating pin
|
1 695 105 428 2013-11-04
5. Insert the bead breaker arm (E) and in doing so,
center the pivot pin (F) with the cylinder shaft (G)
so that the
i
flat part of the pivot pin (F) points outwards.
6. Position the upper washer (D).
7. Insert the rotating pin (C).
8. Re-attach the lower washer (B) and the snap ring
(A).
Fig. 21: Fitting the bead breaker arm
9. Fit the return spring(s) (H) for the bead breaker arm
in the corresponding slots.
Fig. 22: Positioning the return spring(s) for the bead breaker arm
Robert Bosch GmbH