Tabla de contenido
Idiomas disponibles
Idiomas disponibles
,
Insert spray gun holder wireform (h) through hole just
above cleaning tank on left side of handle (viewing from
front of unit). Hold wireform in place and attach a plastic
knob (B) from inside of unit. Tighten by hand.
Attach Detergent Siphon Hose to Pump
The pressure washer is equipped with two detergent
siphoning hoses. One is attached to the cleaning tank and
one is loose for siphoning pressure washer safe detergents
from a bottle or container.
Attach one of the detergent siphon hoses (O) to the barbed
hose fitting (D) on the pump.
IMPORTANT:Only one detergent siphoning hose can be used
at a time. When cleaning tank is not used, make sure
detergent shut-off valve on cleaning tank is in the "Off"
position.
Add Enoine OiJ
1.
Place pressure washer on a flat, level surface.
2.
Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
3.
Using oil funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening.
NOTICE
Improper treatment of pressure washer can damage it and
shorten its life.
DONOT attemptto crankor startthe enginebeforeit hasbeen
properlyserviced with the recommended o il. This may resultin
an enginefailure.
4.
Replace oil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
*
Clean,fresh, unleaded gasoline.
*
A minimum of 87 octane/87 AKI (91 RON). High altitude
use, see High Altitude.
*
Gasolinewith up to 10% ethanol (gasohol) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
NOTICE
Avoid pressure washer damage.
Failureto follow Operator's Manual for fuel
recommendations voids warranty.
DONOTuseunapproved gasolinesuchas E85.
DONOTmix oil in gasoline.
DONOTmodifyengineto run on alternate fuels.
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. See Storage. All fuel is not the
same. If you experience starting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
WARHIHG
_
uel and itsvapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or
death.
WHENADDINGFUEL
* Turnpressure washerOFF and letit coolat least2 minutes
beforeremovingfuelcap. Loosencapslowlyto relievepressure
in tank.
* Fillfuel tankoutdoors.
* DONOToverfilltank.Allowspacefor fuel expansion.
* If fuel spills,wait until it evaporates beforestartingengine.
. Keepfuelawayfrom sparks,openflames,pilot lights,heat,and
otherignitionsources.
* DONOTlight a cigaretteor smoke.
1.
Cleanarea around fuel fill cap, remove cap.
2.
Slowly add regular unleaded fuel (E) to fuel tank (F). Be
careful not to overfill. Allow about 1.5" (4 cm) (6) of
tank space for fuel expansion.
3.
Install fuel cap and wait for any spilled fuelto evaporate.
Tabla de contenido
