Tabla de contenido
ENGLISH
PARTS
1. On/off switch
2. Adjustable zoom wheel
3. Length position indicator
4. Charge/recharge indicator
5. Beard brush
6. Scissors
CHARGING YOUR APPLIANCE
Before using your trimmer for the first time, charge for 4 hours.
1. Ensure the product is switched off.
2. Connect the charging adaptor to the product and then to the mains.
3. The charging indicator will illuminate.
•
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
•
To preserve the life of your batteries, let them run out every 6 months then recharge for
4 hours.
•
On a full charge, your beard trimmer will run for up to 120 minutes of cordless usage.
CORDED
•
Connect the appliance to the mains and turn on.
•
We recommend you let the product charge for a few minutes before using corded.
CAUTION: Extended mains only use will result in the reduction of the battery life.
INSTRUCTIONS FOR USE
•
Cordless use – when the product is switched on and fully charged it can be used in
cordless mode for up to 120 minutes.
•
Switch the product on by sliding up the on/off switch.
•
Always comb your beard or moustache with a fine comb before you start trimming.
•
If you wish to trim your beard hair between 1.5-18mm – attach the short length
adjustable comb.
•
For maintaining and trimming longer beard length between 20-35mm attach the XL
adjustable comb.
4
Charge Level
Charging
Fully Charged
7. Stubble comb (1-5mm)
8. Short length adjustable comb (1.5-
18mm)
9. XL adjustable comb (20-35mm)
10. Adaptor (not shown)
11. Pop-up trimmer
Indicator
LED will show
LED will turn off
Tabla de contenido
