Advanced Configuration; How To Access The Web-Based Utility; Setup > Basic Setup; Internet Setup - Cisco Linksys WRT160N Guia Del Usuario

Chapter 3
Chapter 3:

Advanced Configuration

After setting up the Router with the Setup Wizard (located
on the CD-ROM), the Router will be ready for use. However,
if you'd like to change its advanced settings, use the
Router's web-based utility. This chapter describes each
web page of the utility and each page's key functions. You
can access the utility via a web browser on a computer
connected to the Router.
The web-based utility has these main tabs: Setup,
Wireless, Security, Access Restrictions, Applications &
Gaming, Administration, and Status. Additional tabs will
be available after you click one of the main tabs.
NOTE:
When first installing the Router, you
should use the Setup Wizard on the Setup
CD-ROM. If you want to configure advanced
settings, use this chapter to learn about the
web-based utility.

How to Access the Web-Based Utility

To access the web-based utility, launch the web browser on
your computer, and enter the Router's default IP address,
192.168.1.1, in the Address field. Then, press Enter.
A login screen will appear. (Non-Windows XP users will
see a similar screen.) Leave the User name field blank. The
first time you open the Web-based utility, use the default
password admin. (You can set a new password from the
Administration tab's Management screen.) Click OK to
continue.
Login Screen
Setup > Basic Setup
The first screen that appears is the Basic Setup screen. This
allows you to change the Router's general settings.
Wireless-N Broadband Router
Advanced Configuration
Setup > Basic Setup

Internet Setup

The Internet Setup section configures the Router to your
Internet connection. Most of this information can be
obtained through your ISP.
Internet Connection Type
Select the type of Internet connection your ISP provides
from the drop-down menu. These are the available types:
Automatic Configuration - DHCP
•
Static IP
•
PPPoE
•
PPTP
•
L2TP
•
Telstra Cable
•
Automatic Configuration - DHCP
By default, the Router's Internet Connection Type is set
to Automatic Configuration - DHCP, which should be
kept only if your ISP supports DHCP or you are connecting
through a dynamic IP address. (This option usually applies
to cable connections.)
Internet Connection Type > Automatic Configuration - DHCP
7