ITS EKSELANS RCT 2 Manual Del Usuario página 26

EN
PROBLEM
The LED display is
not lit
No signal
There are no images
or sound
Warning that the
channel is coded/not
available
The remote control
does not work
Forgotten channel
password
There is no signal when
the device is moved to
another room
POSSIBLE CAUSE
The power adapter is dis-
connected
The antenna is disconnected
The antenna is damaged/
not properly configured
No signals are transmitted
An incorrect mode has been
selected
Channel coded/not available Select another channel
The device is turned off.
The remote control is not
pointing at the device
There is an obstacle be-
tween the remote control
and the device
The batteries are dead
The antenna connection at
another site may be different
(lower signal strength which
produces weaker channel
reception or no signal)
POSSIBLE SOLUTION
Check the connection of the
power adapter
Check the antenna con-
nection
Select the correct mode on
the television
Turn on the device
Point the remote control at
the device, no more than
8 metres away from the
remote control sensor and
at a horizontal and vertical
angle of 30º in front of the
equipment.
Ensure that there are no obs-
tacles between the remote
control and the device
Replace the batteries with
new ones
Eliminar el canal bloqueado y
realizar una nueva búsqueda
de los canales
Check the antenna con-
nection or connect a signal
amplifier