Cleaning And Maintenance - Beurer MP 70 Instrucciones De Uso

• Repeat the process of submerging and pulling out six
to seven times, until several layers of paraffin wax have
formed over the treatment areas. If the paraffin wax is
either too hot or too cold for you during the treatment
period, turn the temperature controller clockwise or anti-
clockwise, to increase or decrease the temperature as
required.
• Now put a sheet on the treated area, press it onto the
paraffin wax and twist the end shut. Keep the sheet on
for 20 minutes.
Warning
If you are wearing the plastic sleevers on your feet, do not
run around in them. You could slip.
• After 20 minutes, take the sheet and the layers of wax off
the treated area. Dispose the sheet in the general waste;
it cannot be reused.
• After each use, take the protective grille out of the
paraffin bath.

8. Cleaning and maintenance

Important
If the device is only being used by one person, change the paraffin wax at regular intervals and
clean the paraffin bath whilst doing so.
If the device is being used by several people, the paraffin wax should be changed before each
treatment for reasons of hygiene.
• Pull the mains plug out of the socket.
• Take the protective grille out of the paraffin bath.
• Allow the paraffin wax to solidify overnight.
Warning
Do not use any sharp or pointed objects to remove the
wax block from the paraffin bath. You could damage or
scratch the paraffin bath.
• If the paraffin wax has solidified, press on one end
of the wax block and lift it out of the paraffin bath.
If the wax block cannot be removed easily, turn the
temperature controller to "warm" for ten minutes. Then
remove the mains plug and take the wax block out of
the paraffin bath.
18
6-7 x