Replacing Lamp - 3M MP8795 Guía De Seguridad Del Producto

Replacing Lamp

To reduce the risk of electrical shock, always turn off pr ojector and disconnect power cor d before changing
lamp.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes befor e replacing the
lamp.
To reduce the risk of cuts to fingers and damage to inter nal components, use caution when r emoving lamp
glass that has failed and shattered into sharp pieces.
For maximum lamp life, do not apply shock, handle or scratch the lamp glass when it is hot. Also, do not use an
old or previously used lamp as a r eplacement lamp.
1. Remove lamp access door: The lamp access door is located on the bottom of the machine.Use a screwdriver to unscrew
the cover retaining screw (1) and gently remove the cover (2) and set it aside.
2. Retaining screws: Use a screwdriver to unscrew the lamp module retaining screws. (3)
All lamp module screws must be loosened. These scr ews are self-containing scr ews that cannot be removed
from the lamp module or access door .
3. Remove lamp module: Carefully slide the lamp module out (4) using steady pressure.
To reduce the risk of cuts to fingers from sharp metal fittings and/or decr easing image quality by touching the
lens, do not insert hand into the empty lamp compartment when the lamp has been removed.
4. Insert lamp module: Carefully insert (4) the new lamp module. Ensure that it is fully seated. Tighten the
lamp module retaining screws (3) to secure the lamp module in place.
Optional Lamp: 78-6969-9548-5 (Contact 3M customer Service.)
Insert the hinge tabs on the bottom of the lamp access door, then close and tighten the retaining screw
(1) to secure the door.
Reset the lamp operation hours. See "Reset Lamp Hours" for details.
© 3M 2003
1
2
3M™ Multimedia Projector MP8795 Product Safety Guide
WARNING
Caution
✔
Note
✔
Note
Caution
✔
Note
3 3
4
9