Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INTENDED USE
Before operating the machine, please read the entire manual thoroughly. The 3M™ Multimedia Projector MP8795
was designed, built and tested for use indoors, using 3M™ brand lamps, 3M™ brand ceiling mount
hardware and nominal local voltages. This projector is not intended for household use. The use of other
replacement lamps, outdoor operation or different voltages has not been tested and could damage the projector
or peripheral equipment and/or create a potentially unsafe operating condition.
IMPORTANT SAFEGUARDS
1.
Read and understand all instructions before using.
Pay particular attention to areas where this
WARNING
- Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
Caution - Indicates a potentially hazardous situation which, if not avoided, could result in minor or
moderate injury. It may also be used to alert against unsafe practices.
✓
Note - Used to emphasize important conditions or details.
2.
Close supervision is necessary when any appliance is used by or near children. Do not leave appliance
unattended while in use.
3.
Never look directly into the projector lens when the lamp is on. The high pressure mercury lamp produces
a strong light which could damage your eyesight.
4.
Care must be taken as burns can occur from touching hot parts.
5.
Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged – until it
has been examined by a qualified service technician.
6.
Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
7.
If any extension cord is necessary, a cord with a current rating at least equal to that of the appliance
should be used. Cords rated for less amperage than the appliance may overheat.
8.
Always unplug appliance from electrical outlet before cleaning and servicing and when not in use. Grasp
plug and pull to disconnect.
9.
To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.
10.
To reduce the risk of electric shock, do not disassemble this appliance, but take it to a qualified technician
when service or repair work is required. Incorrect assembly can cause electric shock when the appliance
is subsequently used.
11.
Connect this appliance to a grounded outlet.
12.
Do not expose this projector to direct sunlight, or use it outside.
13.
Keep all ventilation openings free of any obstructions.
14.
Always open the lens shutter or remove lens cap when the projection lamp is on.
15.
The projection lamp contains mercury. Always dispose of it in a proper manner according to local
regulations.
16.
To avoid premature lamp failure, do not change the mounting position of the projector (desktop
➱
mount or ceiling
17.
Al
ways operate machine on a flat, sturdy surface.
18.
Incorrect handling of the battery could result in fire or personal injury.The battery may explode if not
handled properly.
19.
When you dispose the battery, you should obey the law in the relative area or country.
20.
When loading the battery, make sure the plus and minus terminals are correctly oriented as indicated in
the remote control.
21.
Keep the battery away from children and pets.
22.
When not to be used for an extended period, remove the battery from the remote control.
23.
Do not look directly into light beam of laser pointer. The pointer produces a strong light which could
damage your eyesight.
© 3M 2003
Safeguards
desktop mount) and continue to use the same lamp.
3M™ Multimedia Projector MP8795 Product Safety Guide
symbol is shown.
➱
ceiling
5
Tabla de contenido
