Endress+Hauser iTEMP PCP TMT 181 Manual De Utilización página 26

Installation
24
Installation in a field housing (Fig. 4.2)
• Feed the installation screws (Pos. 2) with installation springs (Pos. 3) through the
holes in the head transmitter (Pos. 4). Fix these using the circlips (Pos. 5).
• Screw the head transmitter into the field housing using a screw driver.
Attention:
In order to avoid damaging the head transmitter do not over tighten the installation
screws.
Fig. 4.1: Installation of head transmitter into a
Form B sensor connection head.
Pos.1: Cover
Pos.2:
Installation screws
Fig. 4.2: Installation of head transmitter into a
Pos.3:
Installation springs
Pos.4:
Head transmitter
Pos.5:
Sensor inset with
connection cables
Pos.6:
Circlips
Pos:7:
Cable gland
Pos.1: Cover
Pos.2: Installation screws
Pos.3: Installation springs
Pos.4: Head transmitter
Pos.5: Circlips
Pos:6: Field housing
field housing