• When the product is ready, you can see "READY TO SERVE" on the display. In this case, the speed of the augers
decreases to 30rpm (default); this may be adjusted by changing the submenu settings in the SERVICE section;
It may happen that during production of ice cream, with a temperature of product below -2,0°C/28.4°F, the machine is
switched off, acting on main switch, or stop the rotation of the augers, acting on the augers switch
press of one of the two buttons, main switch or augers switch
When this procedure is activated, the augers will remain in stop position until the "9" becomes "1". After this time
(countdown counter) the augers will return to work and the electronic board will set in the previous condition before of
the shutdown. During the countdown must not be pressed any key.
To avoid reset of the above mentioned "WAIT 9 MINUTES FOR AUGERS" function, it is important that the machine is not
switched 'on' or 'off' when the countdown function is active.
This procedure serves to protect the gears and augers from abnormal loads caused by some ice pieces at the bottom of the
stainless steel. The ice can cause noise deriving from the gears that skid until the complete block of the augers. If the machine
does not restart, call the service support.
In the event the product in the tank is ready, i.e. on "Soft Mode READY TO SERVE", the display may show the following
warning:
This procedure is active when there is a lack of product in the tank. In this case, the solenoid valve will not be fed for a
period of 5 minutes, to avoid the formation of ice on the bottom of the tank; after this time limit the procedure is
deactivated.
If this occurs re-fill the tank.
During the "Soft Mode Wait Please" cooling stage of the product or during product maintenance, the "□" symbol may
appear on the upper left corner of the screen. Read the Solera ECO Soft trouble shooting guide on p.33 for further
information.
SOFT MODE
WAIT PLEASE
Warning! If the mixture contains alcoholic product, consider that 15%, on total mixture, is the maximum value that
can come into contact with plastic parts.
If the horizontal auger is blocked because of ice blocks due to a lack of sugar or to other reasons, such as foreign
bodies in the tank, the augers can undergo a break.
If the product freeze completely turn off the machine, wait until the product becomes completely liquid, empty the
tank and check the cause of the problem (ie. Lack of sugar, failure to close solenoid valve, etc.).
The product must be maintained at a temperature not exceeding 5°C for periods specified by the manufacturer,
but for not more than 5 days. In case of failure of the refrigerator system the product should be inspected to
determine whether it has deteriorated.
The key pad can be locked, with the exception of the MENU key. To lock the keyboard proceed as follows:
1. To view the menu options, press the
2. Use the
or
SOFT MODE
READY TO SERVE
WAIT 9 MINUTES
FOR AUGER
PLEASE REFILL
□
SOFT MODE
WAIT PLEASE
key on the electronic control panel.
keys to scroll to the KEYBOARD screen.
, you can see on the display
LOW MIX
SOFT MODE
READY TO SERVE
Key pad lock
- 27 -
. With the next
□ SOFT MODE
READY TO SERVE