Checking The Fuse And Charging - Chal-tec 10002073 Manual De Instrucciones

Saddle mounting (optional)
1. Insert the lower seat post into the latching
connectors. Bolt the clamp securely.
3. Place the saddle on the seat post and fas-
ten it securely using the side-lying screws.
Ckecking the Fuses and Charging
Important Hints on Battery and Adaptor
• Ensure that the power supply voltage corresponds to the value indicated on the power supply.
• The power supply can be operated with an alternating current of 220 - 240 V.
• Use an appropriate plug adapter if the plug does not fit into your socket.
• Insert the power cord fully into the outlet.
• Do not pull on the cable. Do not bend the cable or place heavy objects on top of it.
• Do not handle the plug with wet hands.
• Hold the plug when pulling it out of the device.
• Do not use a damaged mains plug or a damaged socket.
• Install this unit so that the power cord may be disconnected from the mains socket if a problem
occurs.
Attention
• You must fully charge the battery before first use.
• Charge immediately after each use of the scooter.
• Charge batteries before storing. You must charge the battery every 30 days if the scooter is not
in use.
• Make sure that the batteries never fully run out.
• For safety reasons, do NOT charge for over 24 hours.
• Switch the unit OFF when not in use.
• NEVER leave or store batteries near fire or heat.
2. Adjust the height of the saddle bar by loo-
sening the top clamp on the inner rod of the
saddle bar until the saddle is at a suitable
height and then retighten the clamp.
4. Check that the saddle is securely fastened
with strong upward, downward and side-
ways movements. The saddle should be se-
cure while still allowing for room to move.
12