Briteq LDP Gardenspot 4TC Manual De Instrucciones página 8

ENGLISH
 In the next window you have to select one of the product categories: choose "Architectural Fixtures"
 Now the configuration window will open where you can do all the settings:
1. SELECT FIXTURE: here you have to choose the desired fixture model from the list.
2. SELECT FIXTURE ORDER: here you can choose one of the different projectors in the DMX-chain.
The selected fixture will light up in white color.
3. CHANNEL SETUP: here you can choose the desired channel setup if you want to use the projector
with a DMX-controller.
4. ADDRESS SETUP: you can set the desired DMX start address for the selected projector.
5. WHITE BALANCE: used to match the white color of the projector as close as possible to perfect
white. Press enter to save the new setting to the selected projector: the projector will blink fast to
indicate it was programmed. From now on all color settings will be based on the white balance
settings.
6. COLOR SETUP: used to choose the desired color when the projector is NOT connected to a DMX
controller. (standalone or master/slave). Press enter to save the new setting to the selected
projector: the projector will blink fast to indicate it was programmed.
Example: set the color with the faders to violet (combination of blue and red). Now press the
ENTER button to save the color.
DMX-signal is detected. (standalone or master/slave)
7. FADE SPEED: used to choose the desired color fade speed when the projector is NOT connected to
a DMX controller. (standalone or master/slave). You can set a very slow speed (000) to very fast
speed (245). Press enter to save the new setting to the selected projector: the projector will blink fast
to indicate it was programmed.
Example: set the fade speed with the fader to a desired value. Now press the ENTER button to
save the fade speed.
selected fade speed, when no DMX-signal is detected. (standalone or master/slave)
8. BLACKOUT: used to make sure that the projector turns to blackout when the projector is NOT
connected to a DMX controller. (standalone or master/slave).
Remark for options 6, 7 and 8: the last selected option will be active while the projector is in standalone or
master/slave mode. So if you pressed the ENTER-button for fade speed as the last one, the projector will go
to fade mode as soon as no DMX is detected.
BRITEQ
®

From now on the projector will light up in violet when no

From now on the projector will start fading through all colors at the
6/44
USER MANUAL
LDP-GARDENSPOT 4TC