Mounting The Liner; Mounting The Cable Assembly On The Machine Side - Abicor Binzel Alpha Flux Instructivo De Servicio

6 Putting into operation

6.3 Mounting the liner

1
9
1 Torch neck
2 Protective shield
3
Handle
Fig. 3 Mounting the liner
NOTICE
• New still unused liners have to be shortened to the actual length of the cable assembly.
1 Lay down the cable assembly straight.
2 Unscrew retaining sleeve (6) / clamping screw (7).
3 Insert the new liner (5).
4 Measure the excess length of the liner:
• subtract 15 mm in case of a central connection
• add 1 mm in case of a Lincoln connection
5 Pull out liner (5).
6 Shorten the front side of the liner by the calculated length
7 Debur the edge
8 Insert the liner (5).
9 Tighten retaining sleeve (6) / clamping screw (7).

6.4 Mounting the cable assembly on the machine side

 Fig. 3 Mounting the liner on page EN-8
EN - 8
2
8
4 Central connector KZ-2
5 Liner
6
Support sleeve AF 11
3
4
5
15
6
1
7
7 Clamping screw AF 8
8 LN connection
9
Coaxial cable
BAL.0153 • 2018-08-24
ALPHA FLUX