Manual Code Entry; Automatic Code Search For Some Well-Known Brands - Marmitek TV ANYWHERE REMOTE Modo De Empleo

[21] REC (record)
This key works the same way as the one on your original remote control for your VCR.
In order to avoid mistakes, you have to press this key twice to activate this feature.
[22] PAUSE/SCAN
In VCR or DVD mode: This button works the same way as the one on your original remote
control.
IN TV mode: Coloured key (purple), fasttext control or special equipment functions.
3. PROGRAMMING THE REMOTE CONTROL FOR YOUR
TV, SET-TOP BOX, DVD PLAYER AND SATELLITERECEIVER
To make your remote control suitable for your own equipment, you have to program it once.
You can do this by entering a code, related to the brand and type of equipment you want to
control. You can program any device under any MODE button. For example, if you have two
Set-Top Boxs, you can program Set-Top Box 1 under VCR and Set-Top Box 2 under DVD.

3.1 Manual code entry

Take your code book and search for the list matching the device you are looking for, e.g. TV
or Cable. Next, find the relevant brand (e.g. Sony). Now you will see one or more codes. If
there is more than one code, it depends on your equipment which code is correct. Generally,
the codes are displayed in order of age of the device. Older devices first, newer devices last.
Sometimes you will have to try several codes before you find the right code for your device.
1. Make sure your device is switched on (for example the TV).
2. Press and hold SETUP [7] until the LED indicator stays lit. Release SETUP .
3. Press and release the mode button [3] of the device you want to control (for example
TV).
4. Enter the code from the code book by using the key pad [9]. The LED [2] will extinguish
after the last digit is entered. If you have entered a wrong code, the LED will flash for 3
seconds and then extinguish. You have to repeat steps 2-4.
5. Point the remote at your TV and press the POWER button [1]. Your device should now turn
off. Check other functions (for example for a VCR FF or REW, etc.). If certain functions
are not responding, the entered code is not the correct one. In that case repeat the steps
above with the next corresponding code of your brand.
6. Repeat this procedure from step 1 for the other devices you want to control (VCR, DVD,
SAT,...).

3.2 Automatic code search for some well-known brands

If your brand is listed below, you can use the brand search method (faster than the "manual"
and the "automatic code search").
1. Turn on the device you want to control.
2. Press and hold SETUP [7] until the LED indicator [2] stays lit. Release SETUP.
3. Press the mode button (3) that matches the device you wish to control. The LED [2] will
flash once.
TV Anywhere™ - Universal Remote Control 5