Tabla de contenido
to use your kettle
1 Fill the kettle through either the
spout or lid. To open the lid, pull
back the lid release latch
water level must be between 'MAX'
and 'MIN' (1 cup/200mls).
G
Be economical: do not boil more
water than you need.
G
To improve the quality of your drinks
always use fresh water.
G
Empty the kettle after each use.
2 Close the lid using the lid release
latch.
3 Plug in and switch on. The indicator
light will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
G
If you experience problems
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
"descaling".
G
Your kettle is fitted with a filter to
hold back limescale particles.
G
If you find drops of water under your
kettle, don't worry - it is just
condensation.
boil-dry protection
G
If you switch on with too little water,
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
care and cleaning
G
Before cleaning, unplug your kettle
and let it cool down.
the outside and powerbase
G
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the metal and plastic
surfaces.
the inside
G
Even though your kettle comes with
a filter, you still need to clean the
inside (and the filter) regularly.
. The
the filter
1 Open the lid.
2 Slide the filter out
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 Slide the filter back in to refit
descaling
G
Regular descaling of the flat element
will improve the performance of your
kettle. If the kettle is not descaled
regularly the build up of limescale
may result in the following:
G
G
G
Please note: Failure to descale your
kettle may invalidate your guarantee.
G
When limescale starts to build up on
the heating element, buy a suitable
descaler and descale your kettle.
After descaling, boil with fresh water
several times and discard. Clean any
descaler off the kettle - it can
damage the parts.
G
Some regions of the country have
chalky water. This makes boiled
water look cloudy and leaves a
deposit on the side of the kettle. This
is normal but can be removed with
regular cleaning.
G
Alternatively, to reduce limescale
build up, use filtered water to fill your
kettle.
4
problems may be experienced
with the kettle switching on and
off during use or switching off
before boiling.
the kettle may take longer to boil.
the flat element may be damaged.
.
.
Tabla de contenido
