Idiomas disponibles
Idiomas disponibles
TORQUE WRENCH KIT INSTRUCTIONS
WARNING:
In order to avoid damage to your tool, never set it below 10 newton
meters.
1. Hold the wrench so that the direction arrow and the scale are visible.
2. Unlock the knurled handle by loosening the rear locknut
counter-clockwise.
3. Rotate the knurled handle clockwise until you are near the desired
scale value.
4. Proceed as follows:
• for values of 10, 18, 42: slowly rotate the knurled handle until the
10, 18, 42 mark on the handle coincides with the vertical scale.
• for values of 55, 68, 75: slowly rotate the knurled handle until the 0
mark on the handle coincides with the vertical scale.
Setting
100 kg x cm (10Nm)
180 kg x cm (18Nm)
420 kg x cm (42Nm)
550 kg x cm (55Nm)
650 kg x cm (65Nm)
750 kg x cm (75Nm)
* For different torque values you can start from the table's value and
increase or decrease torque by rotating the handle. Each mark
corresponds to 10kg x cm (1Nm.)
5. Lock the torque setting by screwing the locknut clockwise. When you
reach the desired tightening torque, you will hear a click.
WARNING:
• In order to avoid damage to your tool, remove pressure from the
wrench after you have reached the desired tightening torque.
• Always bring the wrench back to the minimum value after use in order
to maintain torque precision.
• If you have not used the wrench for a long period of time, make a
few clicks with the torque at the scale's lowest value, so that the
wrench will lubricate itself.
• The fork face with the number on it must be on the same side as the
direction arrow and scale.
Setting
180kg x cm (18Nm)
420kg x cm (42Nm)
550kg x cm (55Nm)
550kg x cm (55Nm)
650kg x cm (65Nm)
650kg x cm (65Nm)
2
Vertical Scale Mark
10
16/18
42
55
65
75
Use
Conventional pressure & R410A
Conventional pressure & R410A
Conventional pressure
R410A
Conventional pressure
R410A
www.mastercool.com
English
Handle Mark
10
16/18
42
0
0
0
Wrench
17
19
22
25
28
32
