Cascade QFM E Serie Instrucciones De Instalación página 3

T
RUCK REQUIREMENTS
WARNING: Rated capacity of the truck/
attachment combination is a responsibility
of the original truck manufacturer and may
be less than that shown on the attachment
nameplate. Consult the truck nameplate.
Truck Relief Setting
2000 psi (140 bar) Recommended
2300 psi (160 bar) Maximum
Truck Flow Volume
35E, 45E
(15 L/min.)
➀ Cascade E-Series QFM
petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or
MIL-0-2104B. Use of synthetic or aqueous base hydraulic fluid
is not recommended. If fire resistant hydraulic fluid is required,
special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in reduced mechanism
speeds.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and reduced hydraulic system life.
Carriage Mount Dimension (A)
A
Class II 14.96 in. (380.0 mm)
Class III 18.68 in. (474.5 mm)
GA0028.eps
Auxiliary Valve Functions
Check for compliance with ITA (ISO) standards:
GA0094.eps
684948-R5 EN
➀
Min. Recommended
➁
4 GPM 7 GPM
(26 L/min.)
Push/Pull is compatible with SAE 10W
™
Minimum
15.00 in. (381.0 mm)
18.74 in. (476.0 mm)
Tilt Forward
Hoist Down
Hoist Up
Tilt Pull/Retract
Back
Sheet-Sav
Gripper Down
Max.
➂
10 GPM
(38 L/min.)
ITA (ISO)
Maximum
(1015-1168 mm) long can be used. 42 in.
(1066 mm) forks with bottom taper are
recommended. Sideshifter components (if
equipped) must not protrude in front of carriage
Push/Extend
bars.
OR
Sheet-Sav
™
Release
OR
Gripper Up
OR
™
Engage
OR
GA0170.eps
Carriage
Clean and inspect carriage
bars for damage. Repair any
damaged notches.
WARNING: The QFM™ Push/
Pull requires forks to support the
attachment and load. Forks up to
1.8 in. (45 mm) thick and 40–46 in.
1