Astralpool 62328 Manual De Instalación Y Mantenimiento página 4

C) In mini snap-in niche (Fig. 3c)
Recess required: 60229 / Accessories required: No / Siphonrequired:No
Procedure:
1- Screw the adaptor into the niche.
2- Insert the cable in the niche's stuffing box assembly, then tighten the nut on the stuffing box assembly using the special
spanner included with the niche.
3 - Ease the projector in and turn 90º clockwise (Fig. 5a).
4 - Ensure that the logo is uppermost. (Fig. 4).
Polyester pools
A) On nozzle 38805 (Fig. 3d)
Recess required: 38805
Accessories required: No / Siphon required: Yes
Procedure:
1- Screw the adaptor into the nozzle.
2 - Insert the cable in the nozzle, ease the projector in and turn 90º clockwise (Fig. 5a).
4 - Ensure that the logo is uppermost. (Fig. 4)
Replacing the bulb
1- Give a quarter of a turn anti-clockwise, remove the projector until it has come out of the adaptor (Fig. 5b) and place it
on the edge of the pool.
2- Loosen the stuffing box assembly and then the wire connector; it is very important to follow the steps as shown in Fig. 6.
3- Reconnect the projector.
5. SAFETY AND MAINTENANCE WARNINGS:
• Before any handling ensure that there is NO voltage supplied to the projector.
• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS.
• Do not handle with wet feet.
• Do not clean using abrasive products that could damage the projector.
• The LEDs in this projector are classified as risk group 2. • Under no circumstances should the luminaire be stared into for one minute or more at distances equal to or less than
20 cm. Doing so could damage eyesight.
6. ASSEMBLY AND FUNCTIONING WARNINGS:
• Maximum water temperature 40ºC.
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
• The projector is designed TO OPERATE ONLY WITH A SAFETY TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric compo-
nents which have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• This projector is seawater resistant.
• This projector is resistant to pool treatments described below, always that the concentration values do not exceed the
following levels:
Chlorine
Bromine
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
TYPE OF TREATMENT CONCENTRATION IN WATER
2 mg/l
5 mg/l
4