Freqently Asked Questions - Marmitek SURROUND ANYWHERE 220 Manual Del Usario

7. Freqently asked questions

The transmit light does not go on after DC power is applied to
the transmitter
Check the power outlet and the AC adapter; if possible, check for
correct voltage of the AC adapter.
The transmit light goes out after a few seconds and does not
light again
x
Check the audio connection to the transmitter and ensure that
there is audio present.
x
Disconnect and then reconnect DC power.
No audio at receiver
x
Check the power outlet and the AC adapter; if possible, check for
correct voltage of the AC adapter.
x
Adjust the transmitter volume control.
x
Adjust the receiver volume control.
x
In some cases, there may be strong interference preventing
proper reception of the audio signal which can be caused by 5.8
GHz cordless telephones or 5.8 GHz wireless networks. Either
eliminate the interference, locate the base unit of the cordless
phone in another room, set the wireless network to use the 5.1
GHz frequency band rather than 5.8 GHz, relocate the
transmitter, relocate or reorient the receiver.
Audio is distorted
x
Adjust the transmitter volume control until clipping stops.
x
Adjust the receiver volume control until clipping stops.
x
See part four of the question No audio at the receiver
SURROUND ANYWHERE 220 9