Group Settings - Mitsubishi Electric PAC-SF41SCA Libro De Instrucciones

7-1-2. Group settings

Indoor units, ventilation units, slave system controllers, and local remote controllers are registered in each
group.
(Register ventilation units as interlocked units in accordance with 7-1-3. Setting up interlocked units.)
(1) Group selection
(2) Unit selection
• Registering a unit in a group
• Deleting a unit from a group
• Searching for a unit registered in a group
(1) Group selection
1 The group selection display [ ] moves one position to the right each time the GROUP
is pressed. The group number is then incremented by one, and displayed for two seconds. (The
opposite operation occurs when the
2 The registered minimum address number and the unit type are displayed when a further unit is
registered in the selected group.
Example: Group 1 and 2 are not registered, and the indoor unit at address 005 is registered in group 3
(minimum management group number = 1).
CENTRALIZED
COLLECTIVE
GROUP ON OFF
Initial setting mode
Press
CENTRALIZED
COLLECTIVE
GROUP ON OFF
Select group 2
Press
CENTRALIZED
COLLECTIVE
GROUP ON OFF
Select group 3
Indoor unit 005 now registered.
16
ON/OFF
PROHIBIT
CHECK
ON/OFF FILTER
AUTO
MODE TEMP.
BY-PASS
MODE LOCK
HEAT EX.
SKIP
FILTER
˚C
Set temperature display : [
once.
ON/OFF
PROHIBIT
CHECK
ON/OFF FILTER
AUTO
MODE TEMP.
BY-PASS
MODE LOCK
HEAT EX.
SKIP
FILTER
˚C
once.
ON/OFF
PROHIBIT
CHECK
ON/OFF FILTER
AUTO
MODE TEMP.
BY-PASS
MODE LOCK
HEAT EX.
SKIP
FILTER
˚C
switch is pressed.)
The relevant group number is displayed, and [
displayed after two seconds if nothing has been registered.
] displayed if nothing has been registered.
[ ] displayed after two seconds if nothing has been regis-
tered.
Type (eg [ ]) displayed after two seconds.
switch
] is then