14
3.
5.
min�
17 oz� /
500 ml
7.
5 sec�
. ! . IMPORTANT
The descaling program runs for
approximately 20.minutes�
Bosch Home Appliances
All manuals and user guides at all-guides.com
4.
6.
20.min.
3.. Fill the water tank (5) up to the
descaling mark "0,5 l" (5b) and add the
descaling agent in accordance with the
manufacturer's instructions�
i
i
Note:
If you have hard water, increase the
amount of descaling agent�
4.. Replace the water tank by tilting it
slightly and returning it to its original
position until it clicks into place�
5.. Place a container with a capacity of
at least 17 oz� / 500 ml under the drink
outlet (4d)�
6.. Open the brewing unit (4) by lifting
the handle (4a) and then pushing the
brewing unit up� Place the Service
T DISC (6a) on the T DISC holder (4b)
with the barcode facing down� Make
sure that the flap of the T DISC is
located in the slot in the front�
Close the brewing unit by first bringing
►
it down and then pushing the handle
firmly into the machine until you hear an
audible click�
7.. Press and hold the Start / Stop button
(2) for at.least.5.seconds to start the
descaling program�
Release the Start / Stop button after
►
5 seconds; the machine will run the
descaling cycle automatically� This is
indicated by the Status LED
"Descale required" LED
i
i
Note:
The descaling solution is pumped through
the machine in intervals and then runs into
the container until the water tank is almost
empty� A small amount of liquid is always
left in the tank�
en
F
(3a) and
'
(3c) blinking�