Installation; Speakers - Magnat MC 2 S Notas Importantes Sobre La Instalación Y Certificado De Garantía

operAtIoNAl eleMeNtS AND CoNNeCtIoNS - reAr / CoNNeCtIoNS
1 poWer SWItCH
Switches the device on and sets it in the
standby mode. If the switch is set to the
"OFF" position, the device is disconnected
from the mains supply.
2 MAINS CoNNeCtIoN
For connecting the supplied mains cable.
3 FuSe
Only use a fuse with the parameters
indicated on the rear of the device.
4 SpeAKer terMINAlS
Output for the connection of the supplied
speakers (the correct polarity must be
taken into account).
5 Sub output
Output for connecting an active
subwoofer.
6 reC output
Fixed level output e.g. for the connection
of a tape recorder.
7/8 AuX INputS
Additional audio sources can
connected here.
9 FM ANteNNA CoNNeCtIoN
For connecting the supplied FM indoor
antenna or a house antenna.
10 AM ANteNNA CoNNeCtIoN
For connecting the supplied AM loop
antenna.
GB

INStAllAtIoN

Place the device on a firm, even surface while paying attention to the minimum distances.
tHe MC 2 S SpeAKer Set
The MC 2 S set includes two speakers. These speakers have been adapted to perfectly
match the MC 2 S and we recommend to use these speakers together with the MC 2 S CD
receiver only.
poSItIoNING oF tHe SpeAKerS
In the ideal configuration the speakers and the listening position should form an equilateral
triangle. When the left and right speakers are the same distance from the listening position
their sound arrives at the same time, resulting in a harmonious, natural music reproduction.
There should be a clear line of sight between the loudspeakers and the listening position.
Any sound-absorbing or reflecting obstacles in the path will distort the sound.
be
The speakers are connected to the rear as follows:
right
The MC 2 S set comes with prefabricated speaker cables for the two speakers (2x3m). If
possible, use these cables when connecting the speakers. If required, you can shorten and
strip the cables yourself. Please note that the cables for the front speakers should be the
same length. If you need longer cables, do not extend the cables supplied, but purchase
new, equivalent cables in the desired length from a specialised store.
Loosen the terminal screws of the speakers one after the other and insert the stripped ends
into the designated holes. Then re-tighten the terminal screws. Please ensure that any
protruding wires do not cause a short circuit. Then connect the other end of the cable to the
connecting terminals on the MC 2 S unit in the same way. Make sure you pay attention to
the correct polarity.
15
left